Instructions for use of plastic granulator

1、 Equipment inspection before start-up of plastic granulator

1. Organize the actual operation staff and maintenance personnel to study the operation manual carefully, so that the relevant staff can master the working principle of the machine and equipment. Operation steps, safety precautions, easy to effectively and properly operate the machine and equipment.

2. The whole machine has been inspected and tested in all aspects before leaving the factory. In order to prevent problems in the transportation of granulator equipment, the following work still needs to be done successfully:

(1) Step by step inspection of household appliances line is in line with the provisions, whether there is falling off.

(2) The grounding resistance of the electric heating part of the motor measured by ohmmeter should not be lower than 0.5 Ω.

(3) The reducer motor shall be filled with grease to the center line of oil window, and the grease shall be of high quality. The oil tank of hydraulic station is filled to the center line of oil window.

3. Turn on the main switch power supply, adjust the temperature control of each pivot to "set" temperature, and start the heating button.

4. When the temperature rises to the specified temperature of processing technology, control the temperature for 5 ~ 10 minutes.

5. Check and tighten the screws of the whole unit again.

6. Turn the belt pulley by hand (screw rotation should not be less than 2 ~ 3 turns) to ensure that everything is normal, and install the belt pulley protective cover.

7. Starting aid system: such as lubrication, cooling, etc.

8. Start the main motor to determine whether the rotation direction of the main motor is appropriate.

9. Slowly drip about 500ml, 30 × 10 oil from the discharge port, and idle for about 1 minute for the reinforced and upper models, and about 3 minutes for the standard type. Pay attention to the ammeter and voltmeter. The voltage should be between the rated voltage of + 10V and the current should be stable and without fluctuation.

10. Make sure that everything is normal, and then stop the machine, and the empty machine test run is completed.

11. The machine head (die head) can be installed with or without filter screen (generally assembled in the form of no filter screen when leaving the factory), and the filter screen with required mesh number can be prepared for startup.

12. Check all aspects of the plastic granulator, and prepare to start up after confirming that there is no error.

13. The above procedure flow is generally completed before the plastic granulator leaves the factory, and can still be referred to when starting again.

All normal start-up process flow